Disassembly And Replacement - Toshiba e-STUDIO2500c Service Manual

15.6 Disassembly and Replacement

[A] Fuser unit
[A-1] Fuser unit
Note:
When a new fuser unit is installed, be sure to check whether the fuser-related life counter values
have been cleared in the list printing mode, PM supporting mode or the setting mode (08).
P.15-16 "15.5.4 Fuser unit use status determining circuit"
(1) Open the automatic duplexing unit (ADU)
and 2nd transfer unit (TRU).
(2) Loosen 2 screws, and then take off the fuser
unit.
Note:
The fuser unit is extremely hot. When taking
off the fuser unit, hold the handles of the unit
to avoid a direct touch on the unit.
Notes:
Follow the procedure below for the installa-
tion.
1. Insert the fuser unit into the equipment
and tighten the screws. At this time, turn
the handle to engage the gears of the
equipment and the fuser unit.
2. Fix the 2 screws securely with a coin or a
flathead screwdriver.
3. Check that they are engaged properly by
turning the handle.
May 2006 © TOSHIBA TEC
Fuser unit
Fig. 15-9
Fuser unit
Fig. 15-10
e-STUDIO2500c/3500c/3510c FUSER UNIT / PAPER EXIT SECTION
15 - 17
Handle
15