Toshiba e-STUDIO2500c Service Manual page 354

Notes:
When installing the thermistors, be sure not
to deform them. Also check if the thermistors
are contacted with the fuser belt while they
are pressed. Check the gap between the
thermistors and the pressure roller while they
are being pushed each other in the following
procedure:
1. Remove 2 screws, and take off the entry
guide.
2. Check that the thermistor is contacted
with the fuser belt through the opening.
3. Take off the separation finger unit.
P.15-19 "[A-6] Separation finger unit /
Separation finger"
4. Check that the gap between the pressure
roller center thermistor and the pressure
roller is 1.5 - 2.5 mm through the opening.
e-STUDIO2500c/3500c/3510c FUSER UNIT / PAPER EXIT SECTION
Entry guide
Pressure roller
rear thermistor
Pressure roller
center thermistor ( THM4 )
1.5 - 2.5 mm
Pressure roller
15 - 30
Fig. 15-44
Fig. 15-45
Fig. 15-46
May 2006 © TOSHIBA TEC