Toshiba e-STUDIO2500c Service Manual page 182

[B] Laser unit cooling fan (M29)
(1) Take off the paper dust holder.
P.10-40 "[Q] Paper dust holder"
(2) Disconnect 1 connector, and then take off the
laser unit cooling fan.
Note:
When installing the laser unit cooling fan,
face its labeled side down and insert it all the
way in.
[C] Shutter unit
Note:
Perform steps (1) and (2) only when the Damp Heater Kit (optional) is installed.
(1) Open the board case.
P.2-43 "[K] Board case"
(2) Disconnect 1 connector of the Damp Heater
Kit (optional).
e-STUDIO2500c/3500c/3510c LASER OPTICAL UNIT
Laser unit cooling fan
8 - 14
Fig. 8-16
Fig. 8-17
May 2006 © TOSHIBA TEC