Toshiba e-STUDIO2500c Service Manual page 386

[Q] Cover interlock switch (SW2)
(1) Open the board case.
P.2-43 "[K] Board case"
(2) Take off the right inner cover.
P.2-34 "[P] Right inner cover"
(3) Release the harness out of the 2 clamps,
and then disconnect 1 connector.
(4) Remove 1 clamp.
(5) Remove 3 screws, and then take off the
bracket.
(6) Remove 1 E-ring, and take off the shaft and
switch guide.
(7) Release the latch, and then take off the
Cover interlock switch.
e-STUDIO2500c/3500c/3510c AUTOMATIC DUPLEXING UNIT (ADU)
Switch guide
16 - 22
Connector
Bracket
Fig. 16-34
Shaft
Fig. 16-35
Cover interlock switch
Fig. 16-36
May 2006 © TOSHIBA TEC