Toshiba e-STUDIO2500c Service Manual page 352

Notes:
When installing the pressure roller thermo-
stat, check the gap between the pressure
roller thermostat and the pressure roller
while they are being pushed each other.
1. Remove 2 screws, and take off the entry
guide.
2. Check that the gap between the pressure
roller thermostat and the pressure roller is
1.6 - 2.4 mm through the opening.
e-STUDIO2500c/3500c/3510c FUSER UNIT / PAPER EXIT SECTION
Entry guide
Pressure roller
1.6 - 2.4 mm
Pressure roller
thermostat ( THMO3 )
15 - 28
Fig. 15-41
May 2006 © TOSHIBA TEC