Toshiba e-STUDIO2500c Service Manual page 246

(4) Peel 2 main charger cleaner off the main
charger cleaner rod.
Note:
Attach the main charger cleaner with its
sides contacting the rib of the main charger
cleaner rod as indicated by arrows shown in
the figure.
[C-4] Main charger grid
(1) Take off the Main charger cleaner.
P.11-13 "[C-3] Main charger cleaner"
(2) Lift it up the arm of the front terminal, and
then take off the main charger grid.
Notes:
• Do not touch the mesh area of the grid.
• There are 2 holes on the rear side of the
main charger grid for determining which is
the front or back surface. Be sure to place
the grid so that the 2 holes come as
shown in the figure.
[C-5] Needle electrode
(1) Take off the main charger grid.
P.11-14 "[C-4] Main charger grid"
(2) Take off each terminal cover on both front
and rear sides.
e-STUDIO2500c/3500c/3510c PROCESS UNIT RELATED SECTION
Main charger cleaner
Main charger grid
Hole
11 - 14
Rib
Fig. 11-19
Arm
Fig. 11-20
Terminal cover
Fig. 11-21
May 2006 © TOSHIBA TEC