(3)
Loosen 2 screws, and then take off the sepa-
ration finger unit.
Notes:
•
When installing the separation finger unit,
slide the unit to the rear side of the equip-
ment and fix it at that position.
•
When installing the separation finger unit,
be sure not to scratch the transfer belt
and the pressure roller.
(4)
Remove the spring, and then take off the
separation fingers.
[A-7]
Pressure roller
(1)
Take off the separation finger unit.
P.15-19 "[A-6] Separation finger unit /
Separation finger"
(2)
Release the harness on the front side out of
1 clamp, and then disconnect 1 relay con-
nector.
e-STUDIO2500c/3500c/3510c FUSER UNIT / PAPER EXIT SECTION
/ Pressure roller lamp (LAMP3)
15 - 20
Separation
finger unit
Fig. 15-17
Separation finger
Spring
Fig. 15-18
Clamp
Relay connector
Fig. 15-19
May 2006 © TOSHIBA TEC