[B] Process cover
(1)
Take off the process unit (EPU).
P.11-10 "[A] Process unit (EPU)"
(2)
Take off the main charger cleaner handle.
(3)
Turn the process unit (EPU) to place with the
used toner exit hole comes lower side as
shown in the Figure.
(4)
Disconnect the connectors. (Disconnect 2
connectors each for the process units (EPU
(Y)) and EPU (K), and 1 connector each for
EPU (M) and EPU (C).)
Notes:
•
Be sure to place the process unit (EPU) in
the correct position as shown in Figure to
avoid the damage on the drum.
•
When installing, be sure not to have har-
nesses being loosened.
(5)
Turn the process unit (EPU) to place with the
used toner exit hole comes bottom side as
shown in the Figure.
(6)
Remove 2 screws.
(7)
Release the latch, and then take off the pro-
cess cover.
May 2006 © TOSHIBA TEC
Main charger cleaner handle
Fig. 11-10
Connector
Fig. 11-11
Latch
Fig. 11-12
e-STUDIO2500c/3500c/3510c PROCESS UNIT RELATED SECTION
11 - 11
Used toner
exit hole
Used toner exit hole
Process cover
11