(4)
Remove 2 C-rings and 2 fuser belt guides
from the heat roller.
Notes:
When insaling the fuser belt guide and C-
ring, be sure of the folowing.
•
Be sure that the fuser belt guide is placed
with its flat face inside contacting the
fuser belt (with the mold mark outside).
•
Check that the fuser belt guide is securely
fitted in the groove of the heat roller.
•
Check that the C-ring is also securely fit-
ted in the groove of the fuser belt guide
and avoid the convex portion.
[A-10] Pressure roller thermostat (THMO3)
(1)
Take off the front side cover and transport
guide.
P.15-18 "[A-2] Front side cover"
P.15-19 "[A-5] Transport guide"
(2)
Front side: Release the harness out of the 1
clamp, and then disconnect the 1 relay con-
nector.
(3)
Rear side: Release the harness out of the 5
clamps, and then disconnect the 1 relay con-
nector and 1 connector.
e-STUDIO2500c/3500c/3510c FUSER UNIT / PAPER EXIT SECTION
Fuser belt guide
C-ring
Fuser belt guide
C-ring
Protrusion
Clamp
15 - 26
Heat roller
Fuser belt guide
C-ring
Fig. 15-35
Clamp
Relay connector
Fig. 15-36
Clamp
Connector
Relay connector
Fig. 15-37
May 2006 © TOSHIBA TEC