Toshiba e-STUDIO2500c Service Manual page 268

(3) Insert the flat head screwdriver between the
latch and the frame on the front side of the
upper cover, and pull the toner supply sec-
tion toward the front while turning the screw-
driver in the direction of the arrow shown in
the figure C to release the latch shown in the
figure D.
(4) Insert the flat head screwdriver between the
latch and the frame on the rear side of the
upper cover as shown in the figure E, and
release it by pulling down the screwdriver in
the direction of the arrow in the figure to
make a gap between the latch and the frame.
The latch shown in the figure F is also
released accordingly.
(5) Take off the upper cover.
e-STUDIO2500c/3500c/3510c DEVELOPER UNIT
Latch
Latch
12 - 12
D
Toner supply section
C
Fig. 12-10
Latch
Latch
Fig. 12-11
Upper cover
Fig. 12-12
May 2006 © TOSHIBA TEC
F
E