Toshiba e-STUDIO2500c Service Manual page 119

No. Message
84 Misfeed in copier
Press [HELP]
85 Call for service
86 Please try again after
a while
87 Set standard size
88 Time for Main charger
cleaning
May 2006 © TOSHIBA TEC
State of equipment
Paper jam in the equipment
• Displayed when paper jam
occurred in the equipment
Displayed when motor, sensor,
switch, etc. do not work properly
Displayed when the Department
Code can no be keyed in immedi-
ately after power-ON.
Displayed when the paper size which
is not acceptable is set (depends on
the setting)
Appears when the time for main
charger cleaning comes (at every
output of approx. 10,000 sheets)
5 - 7
Note
Remove the paper in the equipment
according to the messages displayed
on the panel.
Turn OFF the power and solve the
problem, then turn ON the power.
Leave it for a while and key in the
code again
Reset the paper size
If the message is not cleared after
the cleaning, check if there is any
detection error, breakage or poor
connection of the needle electrode
cleaner detection sensor.
e-STUDIO2500c/3500c/3510c CONTROL PANEL
5