4) Original size is determined by the combination of the signals output from each detection point.
Combination charts for size determination of A4 series and LT series are as follows.
[A4 Series]
Size judgement
A3
A4
B4
B5
A4-R
A5
B5-R
A5-R
[LT Series]
Size judgement
LD
LT
LG
LT-R
ST
ST-R
Code
Output signal
1
H
0
* When the platen sensor (S7) is OFF;
•
The followings are determined by output signals from the APS sensors.
-
Size (The combination of the signals satisfy any in the above chart)
Size is displayed on the control panel and a specific paper or reproduction ratio is selected.
-
Size retention (The combination of the signals do not satisfy the above chart)
The latest original size recognized (or no original state) until new paper size is recognized.
-
No original (Output from all the sensors are "1".)
Reproduction ratio and paper are not selected.
•
Size change is always observed and detected.
•
The carriage-1 stays at the standby position even if the reproduction ratio changes correspond-
ing to the change of the original size.
* When the platen sensor (S7) is ON;
The latest original size (or no original state) recognized right before the platen sensor (S7) is turned
ON is retained regardless of the status the APS sensor output signals.
e-STUDIO2500c/3500c/3510c SCANNER
APS-C
APS-R
0
0
0
1
0
0
1
1
0
0
1
1
0
0
0
1
APS-C
APS-R
0
0
0
1
0
0
0
1
1
1
0
1
Original
Not available
L
Available
APS-1
APS-2
0
0
0
0
0
1
0
1
1
1
1
1
1
1
1
1
APS-2
APS-3
0
0
0
0
1
0
1
0
1
0
1
1
6 - 16
APS-3
0
0
0
0
0
0
1
1
May 2006 © TOSHIBA TEC