Toshiba e-STUDIO2500c Service Manual page 216

[B-7] Drawer feed clutch (CLT3/CLT6)
(1) Take off the drawer feeding unit.
P.10-24 "[B-1] Drawer feeding unit"
(2) Disconnect the connector and release the
harness from the harness clamp.
(3) Remove 2 screws and take off the clutch with
the bracket.
Note:
Match the protruding portion of clutch with
the position shown in the figure for assem-
bling
e-STUDIO2500c/3500c/3510c PAPER FEEDING SYSTEM
Clutch bracket
10 - 28
Connector
Fig. 10-47
Bushing
Fig. 10-48
May 2006 © TOSHIBA TEC