Toshiba e-STUDIO2500c Service Manual page 255

Note:
If the gear of the drum drive unit has been
disassembled, install it with the mark on the
gear aligned within the area of the punched
mark on the frame.
(5) Remove 2 screws, and then take off the sen-
sor bracket.
(6) Disconnect 1 connector, and then release
the latch to take off the drum switching
detection sensor.
May 2006 © TOSHIBA TEC
Punched mark Mark
Punched mark
Fig. 11-43
Fig. 11-44
Connector
Fig. 11-45
e-STUDIO2500c/3500c/3510c PROCESS UNIT RELATED SECTION
11 - 23
Sensor bracket
Drum switching
detection sensor
11