Toshiba e-STUDIO2500c Service Manual page 218

Note:
Match the boss of the gear with the hole of
the cover when installing the motor.
[C-2] Tray drive unit
(1) Remove the upper and lower drawers.
(2) Take off the filter bracket.
P.2-42 "[I] FIL board"
(3) Disconnect 1 connector. Remove 4 screws
and take off the tray drive unit with the
bracket.
[D] 2nd drawer transport clutch (Low speed) (CLT4)
(1) Take off the tray drive unit.
P.10-30 "[C-2] Tray drive unit"
(2) Disconnect 1 connector and remove 1 clip to
take off the 2nd drawer transport clutch (low
speed).
Note:
When assembling the clutch, match the pro-
truded portion of the clutch with the position
shown in the figure.
e-STUDIO2500c/3500c/3510c PAPER FEEDING SYSTEM
Tray drive unit
2nd drawer transport clutch ( Low speed )
10 - 30
Fig. 10-52
Fig. 10-53
Fig. 10-54
May 2006 © TOSHIBA TEC