Toshiba e-STUDIO2500c Service Manual page 271

Notes:
• Fill the developer material in the mixer
section under the developer sleeve as
much as possible.
• Check if the developer does not adhered
to the joint of the upper cover indicated in
the figure.
(13) Fit the protrusions on the upper cover in the
6 concaves on the developer unit. Press
each 2 portions on the front and rear side
indicated by arrows to lock 4 latches while
pushing the protrusions on the upper cover
to the 6 concaves to fit them securely.
May 2006 © TOSHIBA TEC
Connecting point of upper cover
Fig. 12-19
Upper cover
Fig. 12-20
Latch
Rear side
Fig. 12-21
e-STUDIO2500c/3500c/3510c DEVELOPER UNIT
12 - 15
Protrusion
Hole
Latch
Front side
12