Drive System - Toshiba e-STUDIO2500c Service Manual

9.

DRIVE SYSTEM

9.1 General Description
Respective units and movable parts of the equipment are operated by corresponding motors.
The following list describes which part or unit is driven by each motor.
Motor
Scan motor (M1)
Toner motor (M2 - M5)
Used toner motor (M6)
Transfer belt motor (M7)
1st transfer motor (M8)
Developer unit motor (M9)
Drum motor (M10)
Drum switching motor (M11)
Shutter motor (M12)
Polygonal motor (M13)
Mirror motor (M14 - M16)
Fuser motor (M17)
Exit motor (M18)
Registration motor (M19)
Feed/transport motor (M20)
Tray-up motor (M21)
ADU motor (M22)
May 2006 © TOSHIBA TEC
Operated section
Carriage-1 and -2
Toner cartridge
Toner bag
• Transfer belt
• Used toner auger of transfer belt
1st transfer roller-Y, -M and -C (contact / release movement)
Developer unit-Y, -M, -C and -K (magnet roller, mixer)
• Drum-Y, -M, -C and -K
• Used toner auger of drum-Y, -M, -C and -K
Transmitting/releasing the drive to the drum-Y, -M, and -C
Slit glass protective shutter
Polygonal mirror
Laser unit third reflecting mirrors for M, C and K
• Fuser unit (Fuser roller, Pressure roller and Fuser roller)
• Bridge unit (option)
Exit roller
• Registration roller
• 2nd transfer roller (contact / release movement)
• 1st drawer transport clutch (Low / High speed): 1st drawer
transport roller
• 1st drawer feed roller
• 1st drawer pickup roller
• 2nd drawer transport clutch (Low / High speed): 2nd
drawer transport roller
• 2nd drawer feed roller
• 2nd drawer pickup roller
• Bypass feed clutch: Bypass transport roller, bypass feed
roller and bypass pickup roller
• 1st drawer tray
• 2nd drawer tray
ADU (Upper, middle and lower transport roller)
9 - 1
Ch.6.
Ch.12.
Ch.12.
Ch.13.
Ch.13.
Ch.12.
Ch.11.
Ch.11.
Ch.8.
Ch.8.
Ch.8.
Ch.15.
Ch.15.
Ch.10.
Ch.13.
Ch.10.
Ch.10.
Ch.16.
e-STUDIO2500c/3500c/3510c DRIVE SYSTEM
9