Toshiba e-STUDIO2500c Service Manual page 310

[B-7] 1st transfer roller cam motor (M8)
(1) Take off the transfer belt.
P.13-16 "[B-2] Transfer belt"
(2) Remove 2 E-rings, and then take off the idler
roller. Then take off the 2 bushings and 2
bearings.
Note:
Be careful not to deform the earth plate of
the tension roller arm on the front side.
(3) Remove 3 E-rings, and then slide the 3 bush-
ings of the cam shaft.
(4) Remove 2 screws, and then take off the TBU
brush bracket.
e-STUDIO2500c/3500c/3510c TRANSFER UNIT
Bearing
Bushing
Bushing
TBU brush bracket
13 - 22
Bushing
Bearing
Idler roller
Fig. 13-34
Fig. 13-35
Fig. 13-36
May 2006 © TOSHIBA TEC