Toshiba e-STUDIO2500c Service Manual page 342

[A-2] Front side cover
(1) Take off the fuser unit.
P.15-17 "[A-1] Fuser unit"
(2) Remove 2 screws, and then take off the front
side cover.
[A-3] Rear side cover
(1) Take off the fuser unit.
P.15-17 "[A-1] Fuser unit"
(2) Remove 2 screws, and then take off the rear
side cover.
Note:
When installing the rear side cover, pull the
harness out of the cover as shown in the fig-
ure so that the harness will not be caught by
the cover.
[A-4] Pressure roller cover
(1) Take off the fuser unit.
P.15-17 "[A-1] Fuser unit"
(2) Remove 2 screws (one on the rear side is a
shoulder screw) and take off the pressure
roller cover.
e-STUDIO2500c/3500c/3510c FUSER UNIT / PAPER EXIT SECTION
Harness
15 - 18
Front side cover
Fig. 15-11
Rear side cover
Fig. 15-12
Pressure roller cover
Fig. 15-13
May 2006 © TOSHIBA TEC