Toshiba e-STUDIO2500c Service Manual page 345

(3) Release the harness on the rear side out of 3
clamps, and then disconnect 1 relay connec-
tor.
(4) Loosen 1 screw, and then slide the bracket to
unfix the pressure roller lamp.
(5) Slide the pressure roller lamp to the rear side
to take it off from the front bracket. Then take
off the pressure roller by lifting it up.
May 2006 © TOSHIBA TEC
Stay
Fig. 15-20
Fig. 15-21
Pressure roller lamp
Bracket
Fig. 15-22
e-STUDIO2500c/3500c/3510c FUSER UNIT / PAPER EXIT SECTION
15 - 21
Clamp
Clamp Relay connector
Bracket
Pressure roller lamp
Pressure roller
15