Toshiba e-STUDIO2500c Service Manual page 154

[G] Carriage-1
(1) Take off the original glass, upper rear cover
and front upper cover.
P.6-18 "[A] Original glass"
P.2-35 "[Q] Upper rear cover"
P.2-28 "[D] Front upper cover"
(2) Move the carriage and position the holes of
the carriage to the holes of the frame.
(3) Remove 2 screws and take off the brackets
fixing the carriage-1 to the wire.
(4) Remove the square seal fixing the lamp har-
ness to the base. Disconnect the connector
of the lamp harness from the SLG board
(5) Rotate the carriage-1 in the direction shown
in the figure at right, not to touch the mirror.
Then take off the carriage-1.
Note:
When replacing the mirror-1, replace the car-
riage-1 together with mirror-1.
Mirror-1 should not be removed.
e-STUDIO2500c/3500c/3510c SCANNER
Connector
6 - 24
Fig. 6-33
Seal
Fig. 6-34
Fig. 6-35
May 2006 © TOSHIBA TEC