Toshiba e-STUDIO2500c Service Manual page 117

No. Message
45 Select the same size
insert2 sheets as the origi-
nals
46 Set insert1 sheets in the
same direction as the origi-
nals
47 Set insert2 sheets in the
same direction as the origi-
nals
48 Set transparency film in A4/
LT direction
49 CHECK PAPER IN LARGE
CAPACITY FEEDER
50 CANNOT PUNCH THIS
SIZE PAPER
51 Remove paper from the fin-
isher
52 Cannot staple this size
53 Remove paper from the
saddle stitch unit
54 Examine stapler
55 Check staple cartridge
56 Check staple cartridge in
the saddle stitch unit
57 Job interrupted job 1 saved Interrupt copying is accepted
58 Ready to resume job 1
59 Cannot use AMS mode
60 More than 200% is not
available
61 Updated the template set-
ting
62 Enter Department Code
63 Cannot copy BLACK mode
Check DEPARTMENT
COUNTER
64 Cannot copy FULL COLOR
mode
Check DEPARTMENT
COUNTER
65 Cannot copy TWIN COLOR
mode
Check DEPARTMENT
COUNTER
May 2006 © TOSHIBA TEC
State of equipment
Displayed when the size of insertion
sheet (sheet 2) is different from that
of other pages at Sheet Insertion
Mode
Displayed when the direction of
insertion sheet (sheet 1) is different
from that of other pages at Sheet
Insertion Mode
Displayed when the direction of
insertion sheet (sheet 2) is different
from that of other pages at Sheet
Insertion Mode
Displayed when the selected paper
size is other than A4/LT at OHP
mode
Papers in LCF are set incorrectly
Displayed when the selected paper
size is not specified for hole punching
Displayed when the paper sizes are
mixed at Staple Sorting Mode
Displayed when the paper size is not
specified for stapling at Staple Sort-
ing Mode
Finisher is full of papers
Trouble in the stapler unit in finisher
No stapler in finisher section
No stapler in saddle stitch unit
Interrupt copying is cancelled
(finished)
Displayed when reproduction ratio is
set to be over 200% at AMS Mode on
RADF
Displayed when reproduction ratio is
set manually to be over 200% on
RADF
Displayed when the template stored
is recalled by pressing [TEMPLATE]
button
Displayed when a button is pressed
while the department management
setting is available
Displayed when the number of print-
outs exceeds the limit number of
department counter
Displayed when the number of print-
outs exceeds the limit number of
department counter
Displayed when the number of print-
outs exceeds the limit number of
department counter
5 - 5
Note
Set the reproduction ratio 200% or
below manually
Set the reproduction ratio 200% or
below
e-STUDIO2500c/3500c/3510c CONTROL PANEL
5