Toshiba e-STUDIO2500c Service Manual page 358

Note:
When installing the thermistors, be sure not
to deform them. Also check if the thermistors
are contacted with the fuser belt while they
are pressed.
[A-15] Exit sensor (S26)
(1) Take off the fuser unit.
P.15-17 "[A-1] Fuser unit"
(2) Open the jam access cover.
(3) Remove 3 screws and take off the cover (A).
e-STUDIO2500c/3500c/3510c FUSER UNIT / PAPER EXIT SECTION
Fuser belt
front thermistor
15 - 34
Fig. 15-56
Jam access cover
Fig. 15-57
Cover (A)
Fig. 15-58
May 2006 © TOSHIBA TEC