[A-11] Bypass feed clutch (CLT8)
(1)
Take off the bypass tray and hinge assembly.
P.10-15 "[A-2] Hinge assembly"
(2)
Disconnect 1 connector and release the har-
ness clamp.
(3)
Remove the E-ring and the bushing.
(4)
Remove 3 screws and take off the bracket.
(5)
Remove the bushing and the bypass feed
clutch.
Note:
Match the protruding portion of the clutch
and bracket for assembling.
[A-12] Bypass separation roller
(1)
Take off the bypass unit.
P.10-14 "[A-1] Bypass unit"
(2)
Remove 3 screws and take off the lower
plate.
e-STUDIO2500c/3500c/3510c PAPER FEEDING SYSTEM
Connector
Bypass feed clutch
Bracket-1
Lower plate
10 - 22
Harness clamp
Fig. 10-30
Bracket-2
Bushing
Fig. 10-31
Fig. 10-32
May 2006 © TOSHIBA TEC
E-ring