[E] 2nd drawer transport clutch (High speed) (CLT5)
(1)
Take off the tray drive unit.
P.10-30 "[C-2] Tray drive unit"
(2)
Disconnect 1 connector and remove 2
screws to take off the whole set of the clutch.
(3)
Take off the bracket, shaft, gear and 2 bush-
ings.
Note:
When assembling the clutch, match the pro-
truded portion of the clutch with the position
shown in the figure.
[F] 1st drawer detection switch (SW5) / 2nd drawer detection switch (SW6)
(1)
Take off the tray drive unit.
P.10-30 "[C-2] Tray drive unit"
(2)
Disconnect 1 connector each from both
switches. Then release 2 latches to take off
the switches by pushing them out toward the
drawer.
May 2006 © TOSHIBA TEC
2nd drawer transport clutch ( High speed )
Fig. 10-55
1st drawer detection switch
2nd drawer detection switch
Fig. 10-56
e-STUDIO2500c/3500c/3510c PAPER FEEDING SYSTEM
10 - 31
10