Toshiba e-STUDIO2500c Service Manual page 380

[F] ADU cover
(1) Take off the ADU opening/closing switch.
P.16-15 "[D] ADU opening/closing switch
(SW7)"
(2) Remove 4 screws and take off the ADU
cover.
[G] Paper guide
(1) Open the automatic duplexing unit.
(2) Open the paper guide.
(3) Release the fulcrum on the front side and
take off the paper guide.
[H] ADU clutch (CLT7)
(1) Take off the automatic duplexing unit and
ADU cover.
P.16-14 "[B] Automatic Duplexing Unit
(ADU)"
P.16-16 "[F] ADU cover"
(2) Remove 1 E-ring. Cut off a binding band and
disconnect 1 connector. Then take off the
ADU clutch.
Notes:
• When installing the ADU clutch, attach a
rotation protection.
• When installing the E-ring, make sure that
the latches of both ends of E-ring are on
the flat part of the shaft.
e-STUDIO2500c/3500c/3510c AUTOMATIC DUPLEXING UNIT (ADU)
2
Fulcrum
Paper guide
Binding band
Rotation
ADU clutch
protection
16 - 16
ADU cover
Fig. 16-16
1
Fig. 16-17
Shaft
E-ring
Fig. 16-18
May 2006 © TOSHIBA TEC