Toshiba e-STUDIO2500c Service Manual page 307

(4) Remove 1 screw, 2 gears, 2 pins and 1 bear-
ing on the rear side of the drive roller.
(5) Remove 2 screws, and then take off the
Drive roller cleaning bracket.
(6) Peel the drive roller cleaning mylar.
Note:
Attach the drive roller cleaning mylar on the
position shown in the figure within the error
of 1 mm or less (by slightly pushing it to the 2
edges of the drive roller cleaning blade in the
direction of the arrow).
May 2006 © TOSHIBA TEC
Bearing
Gear
Pin
Fig. 13-25
Drive roller
cleaning bracket
Fig. 13-26
Drive roller cleaning bracket
Drive roller
cleaning mylar
Fig. 13-27
e-STUDIO2500c/3500c/3510c TRANSFER UNIT
13 - 19
Pin
Drive roller
Gear
13