Toshiba e-STUDIO2500c Service Manual page 198
Multifunctional digital color systems
Hide thumbs
Also See for e-STUDIO2500c:
- Operator's manual (414 pages) ,
- Scanning manual (156 pages) ,
- Colour manual (8 pages)
Table of Contents
Advertisement
[D] Drawer feeding
[D-1]
2nd drawer
•
The feed clutch (CLT6) and the transport clutch (high speed) (CLT1, 5) are turned ON, and the
pickup roller, feed roller and transport roller are rotated to start feeding paper.
•
Passing of the leading edge of the paper turns ON the 2nd drawer feed sensor (S34), then the feed
clutch (CLT6) and transport clutch (high speed) (CLT1, 5) is turned OFF then back ON.
•
Passing of the leading edge of the paper turns ON the registration sensor (S28) and the paper is
aligned by the registration roller.
•
The transport clutch (high speed) (CLT1, 5) is turned OFF and the transport roller is stopped.
•
The registration motor (M19) and transport clutch (low speed) (CLT2, 4) are turned ON and the
paper is transported to the 2nd transfer position.
[D-2]
1st drawer
•
The feed clutch (CLT3) and the transport clutch (high speed) (CLT1) are turned ON, and the pickup
roller, feed roller and transport roller are rotated to start feeding paper.
•
Passing of the leading edge of the paper turns ON the 1st drawer feed sensor (S30), then the feed
clutch (CLT3) and the transport clutch (high speed) (CLT1) are turned OFF then back ON.
•
Passing of the leading edge of the paper turns ON the registration sensor (S28) and the paper is
aligned by the registration roller.
•
The feed clutch (CLT3) and the transport clutch (high speed) (CLT1) is turned OFF and the transport
roller is stopped.
•
The registration motor (M19) and transport clutch (low speed) (CLT2) are turned ON and the paper
is transported to the 2nd transfer position.
e-STUDIO2500c/3500c/3510c PAPER FEEDING SYSTEM
10 - 10
May 2006 © TOSHIBA TEC
Advertisement
Table of Contents
