Toshiba e-STUDIO2500c Service Manual page 230

[U] 1st drawer transport clutch (High speed) (CLT1)
(1) Take off the feed/transport gear unit.
P.10-41 "[T] Feed/transport gear unit"
(2) Remove 2 screws, and then take off the 1st
drawer transport clutch (High speed) with its
bracket.
(3) Remove the shaft and gear from the 1st
drawer transport clutch (High speed).
[V] 1st drawer transport roller
(1) Take off the registration guide.
P.10-33 "[J] Registration guide"
(2) Take off the feed/transport motor.
P.10-41 "[S] Feed/transport motor (M20)"
(3) Remove 2 clips to move 2 bushings to the
inside.
(4) Lift up the 1st drawer transport roller and
take it off to the rear side.
(5) Remove 1 E-ring, 1 gear and 2 bushings
from the 1st drawer transport roller.
e-STUDIO2500c/3500c/3510c PAPER FEEDING SYSTEM
10 - 42
1st drawer
transport clutch
( High speed )
Fig. 10-85
1st drawer
transport roller
Fig. 10-86
May 2006 © TOSHIBA TEC