2. Install the sleeve with its groove aligned
with the pin on the drum shaft.
3. Insert the drum shaft to the drum while
aligning the position of the pin on the
shaft with the groove of the drum. After
they are aligned, push the shaft fully in to
engage the groove and pin with the
sleeve.
Note:
Be sure to align the position before inserting
the shaft. If the drum or drum shaft is rotated
with the sleeve engaged with the groove
and pin, sleeve may be deformed.
4. Install the bearing on the front side of the
drum shaft.
[C-7]
Drum cleaning blade
(1)
Take off the Drum.
P.11-15 "[C-6] Drum"
(2)
Remove 3 screws and take off the drum
cleaning blade.
Note:
Be sure not to touch or scratch the edge of
the cleaning blade.
May 2006 © TOSHIBA TEC
Pin
Groove
Sleeve
Fig. 11-28
Pin
Groove
Drum
Fig. 11-29
Drum cleaning blade
Fig. 11-30
e-STUDIO2500c/3500c/3510c PROCESS UNIT RELATED SECTION
11 - 17
Drum shaft
Drum shaft
11