Toshiba e-STUDIO2500c Service Manual page 220

[G] Paper feed guide assembly
(1) Take off the ADU.
P.16-14 "[B] Automatic Duplexing Unit
(ADU)"
(2) Take off the bypass unit.
P.10-14 "[A] Bypass unit"
(3) Take off the 2nd transfer unit.
P.13-24 "[C-1] 2nd transfer unit (TRU)"
(4) Disconnect 1 connector, and then release
the harness from 2 hooks.
(5) Remove 3 screws, and then take off the
paper feed guide assembly by sliding it to the
rear side slightly.
Note:
When installing the assembly, be sure not to
deform the Mylar on the transport path.
[H] 2nd drawer feed sensor (S34)
(1) Take off the paper feed guide assembly.
P.10-32 "[G] Paper feed guide assembly"
(2) Remove the seal and disconnect 1 connector
to take off the 2nd drawer feed sensor.
e-STUDIO2500c/3500c/3510c PAPER FEEDING SYSTEM
2nd drawer feed sensor
10 - 32
Paper feed guide assembly
Fig. 10-57
Fig. 10-58
May 2006 © TOSHIBA TEC