Toshiba e-STUDIO2500c Service Manual page 314

[C-2] 2nd transfer roller
(1) Open the 2nd transfer unit.
(2) Remove 1 clip, 1 bearing and 1 bushing (with
bearing) on the front side of the 2nd transfer
roller.
(3) Remove 1 clip, 1 bearing and 1 bushing (with
bearing) on the rear side of the 2nd transfer
roller.
(4) Take off the 2nd transfer roller.
Note:
Be careful not to drop the clip, bearing and
bushing into the inside of the 2nd transfer
unit.
[C-3] TRU cover
(1) Take off the 2nd transfer unit.
P.13-24 "[C-1] 2nd transfer unit (TRU)"
(2) Remove 4 screws and take off the TRU
cover.
Note:
When installing the TRU cover, be sure not
to damage the mylar.
[C-4] Paper clinging detection sensor (S27)
(1) Take off the TRU cover.
P.13-26 "[C-3] TRU cover"
(2) Remove 1 screw, and then disconnect the
connector to take off the sensor bracket.
e-STUDIO2500c/3500c/3510c TRANSFER UNIT
2nd transfer roller
Bearing
Clip
Bushing ( with bearing )
Mylar
Connector
13 - 26
Bearing Clip
Bushing
( with bearing )
Fig. 13-46
TRU cover
Fig. 13-47
Sensor bracket
Fig. 13-48
May 2006 © TOSHIBA TEC