Toshiba e-STUDIO2500c Service Manual page 343

[A-5] Transport guide
(1) Take off the rear side cover.
P.15-18 "[A-3] Rear side cover"
(2) Release the harness out of the clamp, and
then disconnect 1 relay connector.
(3) Remove 2 screws and take off the transport
guide.
Note:
When installing the transport guide, hook the
3 latches of the transport guide onto the
holes of the frame.
[A-6] Separation finger unit / Separation finger
(1) Take off the front side cover and transport
guide.
P.15-18 "[A-2] Front side cover"
P.15-19 "[A-5] Transport guide"
(2) Loosen 2 pressure screws, and then remove
2 springs.
Note:
When installing, tighten the 2 pressure
screws securely until they are no longer
moved.
May 2006 © TOSHIBA TEC
Fig. 15-14
Fig. 15-15
Spring
Fig. 15-16
e-STUDIO2500c/3500c/3510c FUSER UNIT / PAPER EXIT SECTION
15 - 19
Clamp
Relay connector
Transport guide
Pressure screw
15