[D] Discharge LED (ERS-Y, ERS-M, ERS-C, ERS-K)
Dedicated discharge LEDs which correspond to the process units (EPU (Y, M, C, K)) respectively are
installed.
•
Process unit (EPU (Y)): Discharge LED (ERS-Y)
•
Process unit (EPU (M)): Discharge LED (ERS-M)
•
Process unit (EPU (C)): Discharge LED (ERS-C)
•
Process unit (EPU (K)): Discharge LED (ERS-K)
Take off the corresponding the discharge LED.
(1)
Take off the process unit (EPU).
P.11-10 "[A] Process unit (EPU)"
(2)
Disconnect 1 relay connector from the dis-
charge LED. Remove 1 screw and take off
the duct.
Notes:
•
When installing the duct, hang the 1 hook
of the duct on the hole of the frame.
•
When installing the duct, be sure to hold
the harness between the duct and main
frame in order not to have the duct lose
contact with the main frame.
•
Since the actuator is installed on the duct
for the discharge LED (ERS-K), be sure
to install it in the correct position.
(3)
Remove the discharge LED from the protru-
sion of the duct, and slide it to take it off.
May 2006 © TOSHIBA TEC
Fig. 11-33
Discharge LED
Duct
Fig. 11-34
e-STUDIO2500c/3500c/3510c PROCESS UNIT RELATED SECTION
11 - 19
Duct
Hook
Relay
connector
Protrusion
11