Toshiba e-STUDIO2500c Service Manual page 228

(7) Remove each 1 screw fixing the both front
and rear holders.
(8) Remove 2 clips, and then move the front and
rear holders and bushings to the inner side.
(9) Move the registration roller (metal) to the rear
side, and then take it off from the front side.
[Q] Paper dust holder
(1) Take off the registration roller (metal).
P.10-38 "[P] Registration roller (Metal)"
(2) Remove 2 screws, and then take off the
paper dust holder.
[R] 1st drawer transport clutch (Low speed) (CLT2)
(1) Open the board case.
P.2-43 "[K] Board case"
(2) Disconnect 1 connector and remove 1 clip to
take off the 1st drawer transport clutch (Low
speed).
Note:
When assembling the clutch, match the pro-
truded portion of the clutch with the position
shown in the figure.
e-STUDIO2500c/3500c/3510c PAPER FEEDING SYSTEM
Registration roller ( Metal )
1st drawer transport clutch ( Low speed )
10 - 40
Fig. 10-80
Paper dust holder
Fig. 10-81
Fig. 10-82
May 2006 © TOSHIBA TEC