Toshiba e-STUDIO2500c Service Manual page 286

[N] Ozone exhaust duct
(1) Take off the ozone filter-1 and rear cover-2.
P.12-29 "[M] Ozone filter-1"
P.2-36 "[S] Rear cover-2"
(2) Remove 1 screw. Disconnect the 1 relay
connector, and then take off the ozone
exhaust duct.
[O] Ozone exhaust fan (M24)
(1) Take off the ozone exhaust duct.
P.12-30 "[N] Ozone exhaust duct"
(2) Release the 7 latches and take off the ozone
exhaust fan.
[P] Internal cooling fan (M23)
(1) Open the board case.
P.2-43 "[K] Board case"
(2) Remove 2 screws. Disconnect 1 relay con-
nector, and take off the internal cooling duct.
e-STUDIO2500c/3500c/3510c DEVELOPER UNIT
Latch
Internal cooling duct
12 - 30
Ozone exhaust duct
Relay connector
Fig. 12-62
Ozone exhaust fun
Fig. 12-63
Fig. 12-64
May 2006 © TOSHIBA TEC