Toshiba e-STUDIO2500c Service Manual page 276

[B-6] Developer sleeve
(1) Take off the doctor blade.
P.12-16 "[B-3] Doctor blade"
(2) Rear side: Remove 1 screw and take off the
polarity adjustment plate.
Note:
Before disassembling, record (mark if any)
the scale pointed by the polarity adjustment
lever. Then match the polarity adjustment
plate at the scale previously recorded when
reassembling.
(3) Release the 3 latches and take off the gear
holder.
Note:
When installing the developer sleeve, match
the positions of the idler gear shaft and the
hole of the gear holder.
(4) Remove the idler shaft and 2 idler gears, and
then remove the parts installed on the devel-
oper sleeve shaft (in order of the C-ring,
gear, developer guide, and bearing).
e-STUDIO2500c/3500c/3510c DEVELOPER UNIT
Polarity adjustment plate
Latch
Gear holder
Developer guide
Gear
Idler gear shaft
12 - 20
Scale pointed
Fig. 12-33
Idler gear shaft
Latch
Latch
Fig. 12-34
Bearing
Idler gear
Fig. 12-35
May 2006 © TOSHIBA TEC