Toshiba e-STUDIO2500c Service Manual page 244

Note:
When installing, fit 2 bosses of the process
cover and 1 boss of the used toner drain into
respective boss holes securely.
[C] Cleaning unit/ Developer unit
[C-1] Cleaning unit/ Developer unit
(1) Take off the process cover.
P.11-11 "[B] Process cover"
(2) Remove 2 screws and take off the front
retainer.
Note:
Be sure not to lose the bearing installed on
the front retainer.
(3) Release 1 latch on the rear side of the devel-
oper unit to open the cleaner unit in the
direction of the arrow. Slide the cleaning unit
to the rear side to separate it from the devel-
oper unit.
Notes:
• Be sure not to touch, spit or scratch on
the drum surface.
• Avoid a direct sunlight onto the drum.
Move it to a dark place as soon as it is
taken off.
e-STUDIO2500c/3500c/3510c PROCESS UNIT RELATED SECTION
Process cover
Boss
Hole
Front retainer
Cleaning Unit
Developer unit
11 - 12
Boss
Used toner
Boss
discharge section
Fig. 11-13
Bearing
Fig. 11-14
Latch
Fig. 11-15
May 2006 © TOSHIBA TEC
Hole