Toshiba e-STUDIO2500c Service Manual page 361

[C] Exit unit
[C-1] Exit unit
(1) Take off the fuser unit.
P.15-17 "[A-1] Fuser unit"
(2) Remove 2 screws and take off the exit duct.
(3) Loosen 2 screws and take off the exit unit.
[C-2] Upper exit roller / Lower exit roller
(1) Take off the exit unit.
P.15-37 "[C-1] Exit unit"
(2) Remove 2 screws.
(3) Remove the exit flame from the exit duct
base.
Note:
When installing the exit flame, hook the
flame of the exit flame onto the 2 hooks of
the exit duct base.
May 2006 © TOSHIBA TEC
Fig. 15-63
Fig. 15-64
Exit flame
Exit duct base
Fig. 15-65
e-STUDIO2500c/3500c/3510c FUSER UNIT / PAPER EXIT SECTION
15 - 37
Exit duct
Exit unit
Hook
15