Toshiba e-STUDIO2500c Service Manual page 275

[B-5] Auto-toner sensor (S22, S23, S24, S25)
The auto-toner sensors are installed in the process units (EPU (Y, M, C, K)).
• Process unit (EPU (Y)): Auto-toner sensor (S22)
• Process unit (EPU (M)): Auto-toner sensor (S23)
• Process unit (EPU (C)): Auto-toner sensor (S24)
• Process unit (EPU (K)): Auto-toner sensor (S25)
(1) Take off the corresponding the process unit
(EPU), and then take off the developer unit to
remove the developer material out of the
unit.
P.11-10 "[A] Process unit (EPU)"
P.11-12 "[C-1] Cleaning unit/ Developer
unit"
P.12-11 "[B-2] Developer material"
(2) Disconnect the connector.
(3) Hold the locking part to lift it up, and then turn
the auto-toner sensor counterclockwise for
90 degrees to take it off.
May 2006 © TOSHIBA TEC
Connector
Fig. 12-31
Locking part
Fig. 12-32
e-STUDIO2500c/3500c/3510c DEVELOPER UNIT
12 - 19
Auto-toner sensor
12