Toshiba e-STUDIO2500c Service Manual page 363

[D] Fuser motor (M17)
(1) Take off the fuser unit.
P.15-17 "[A-1] Fuser unit"
(2) Open the board case.
P.2-43 "[K] Board case"
(3) Remove 2 screws, and then disconnect the
connector to take off the fuser motor.
(4) Release 1 locking support, and then take off
the fuser motor.
[E] Fuser drive unit
(1) Take off the fuser unit, exit section drive unit,
fuser motor and internal cooling fan.
P.15-17 "[A-1] Fuser unit"
P.15-39 "[F] Exit section drive unit"
P.15-39 "[D] Fuser motor (M17)"
P.12-30 "[P] Internal cooling fan (M23)"
(2) Remove 3 screws and take off the harness
from 3 harness clamps. Slide the fuser drive
unit in the upper right direction to take it off.
[F] Exit section drive unit
(1) Open the board case.
P.2-43 "[K] Board case"
(2) Release the harness out of the clamp, and
then disconnect the 2 connectors.
(3) Remove 2 screws and take off the exit sec-
tion drive unit.
May 2006 © TOSHIBA TEC
Locking support
Fuser motor
Connector
Fig. 15-69
Fig. 15-70
Exit section drive unit
Fig. 15-71
e-STUDIO2500c/3500c/3510c FUSER UNIT / PAPER EXIT SECTION
15 - 39
Fuser drive unit
Connector
Relay connector
15