Configuring Key Vault Settings For Thales E_Security; Keyauthority (Teka) - Brocade Communications Systems StoreFabric SN6500B User Manual

11. Review important messages, then click Next.
FIGURE 254
12. Review post-configuration instructions, which you can copy to a clipboard or print for later.
13. Click Finish to exit the Configure Switch Encryption wizard.
14. Refer to
Configuring key vault settings for Thales e_Security keyAuthority (TEKA)
The following procedure assumes you have already configured the initial steps in the Configure
Switch Encryption wizard. If you have not already done so, go to
on page 592.
Figure 255
Brocade Network Advisor SAN User Manual
53-1002696-01
After configuration of the encryption group is completed, the Management application sends
API commands to verify the switch configuration. See
results" on page 629 for more information.
The Next Steps dialog box displays
certificates for the encryption switch are displayed.
Next Steps dialog box
"Understanding configuration status results"
shows the key vault selection dialog box for TEKA.
Creating a new encryption group
"Understanding configuration status
(Figure 254). Instructions for installing public key
on page 629.
"Creating a new encryption group"
20
613