Ip Address (Out-Of-Band) - Dell Networking 7048 Reference Manual

console(config-if)#

ip address (Out-of-Band)

Use the ip address command in Interface Configuration mode to set an IP
address for the out-of-band interface. Use the no form of this command to
return the ip address configuration to its default value.
Syntax
ip-address
ip address {
no ip address
Parameter Description
Parameter
ip-address
mask
prefix-length
dhcp
Default Configuration
The out-of-band interface (service port) obtains an IP address via DHCP by
default.
Command Mode
Interface (Out-of-Band) Configuration mode
User Guidelines
When setting the netmask/prefix length on an IPv4 address, a space is
required between the address and the mask or prefix length. Setting an IP
address on the out-of-band port enables switch management over the service
port.
514
IP Addressing Commands
mask prefix-length
{ |
Description
Specifies a valid IP address.
Specifies a valid subnet (network) mask IP address.
The number of bits that comprise the IP address prefix. The
prefix length must be preceded by a forward slash (/). (Range: 1-
30 bits)
Obtain the out-of-band interface address via DHCPv4.
} | dhcp}