Port-Channel Local-Preference - Dell Networking 7048 Reference Manual

short — Specifies a short timeout value.
•
Default Configuration
The default port timeout value is long.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
This command has no user guidelines.
Example
The following example assigns an administrative LACP timeout for port 1/0/8
to a long timeout value.
console(config)#interface gigabitethernet 1/0/8
console(config-if-1/0/8)#lacp timeout long

port-channel local-preference

Use the port-channel local-preference command in Interface Config mode to
enable the local-preference mode on a port-channel (LAG) interface or range
of port-channel interfaces.
Use the no form of the command to remove the local preference.
Syntax
port-channel local-preference
no port-channel local-preference
Default Configuration
By default, port channels are not configured with local preference.
Command Mode
Interface Config (port-channel) mode
643
Port Channel Commands