Switchport General Pvid - Dell Networking 7048 Reference Manual

switchport general pvid

Use the switchport general pvid command in Interface Configuration mode
to configure the Port VLAN ID (PVID) when the interface is in general mode.
Use the switchport mode general command to set the VLAN membership
mode of a port to "general." To configure the default value, use the no form of
this command.
Syntax
vlan-id
switchport general pvid
no switchport general pvid
vlan-id — PVID. The VLAN ID may belong to a non-existent VLAN.
•
Default Configuration
vlan-id
The default value for the parameter is 1 when the VLAN is enabled.
Otherwise, the value is 4093.
Command Mode
Interface Configuration (gigabitethernet, port-channel, tengigabitethernet)
mode
User Guidelines
Setting a new PVID does NOT remove the previously configured PVID VLAN
from the port membership.
Example
The following example shows how to configure the PVID for 1/0/8, when the
interface is in general mode.
console(config)#interface gigabitethernet 1/0/8
console(config-if-1/0/8)#switchport general pvid 234
832
VLAN Commands