Dell Networking 7048 Reference Manual page 1002

Syntax
show ip helper-address [
interface — Optionally specify an interface to limit the output to the
•
configuration of a single interface. The interface is identified as vlan vlan-
id.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode, Config mode and all Config sub-modes
User Guidelines
Field
Interface
UDP Port
Discard
Hit Count
Server Address
Example
show ip helper-address
IP helper is enabled
Interface
1002
IP Helper/DHCP Relay Commands
interface
Description
The relay configuration is applied to packets that arrive on this
interface. This field is set to "any" for global IP helper entries.
The relay configuration is applied to packets whose destination
UDP port is this port. Entries whose UDP port is identified as
"any" are applied to packets with the destination UDP ports listed
in Table 47-1.
If "Yes", packets arriving on the given interface with the given
destination UDP port are discarded rather than relayed. Discard
entries are used to override global IP helper address entries which
otherwise might apply to a packet.
The number of times the IP helper entry has been used to relay or
discard a packet.
The IPv4 address of the server to which packets are relayed.
UDP Port Discard
]
Hit Count Server Address