Ipv6 Address (Interface Config) - Dell Networking 7048 Reference Manual

server-address — Valid IPv4 or IPv6 addresses of the name server. (Range:
•
1–255 characters)
Default Configuration
No name server IP addresses are specified.
Command Mode
Global Configuration mode
User Guidelines
Server preference is determined by entry order.
Up to eight servers can be defined in one command or by using multiple
commands. Use the
configured name servers.
Example
The following example sets the available name server.
console(config)#ip name-server 176.16.1.18

ipv6 address (Interface Config)

Use the ipv6 address command to set the IPv6 address of the management
interface. Use the no form of this command to reset the IPv6 address to the
default.
Syntax
prefix/prefix-length
ipv6 address {
no ipv6 address
prefix —Consists of the bits of the address to be configured.
•
prefix-length —Designates how many of the high-order contiguous bits of
•
the address make up the prefix.
• eui64— The optional eui-64 field designates that IPv6 processing on the
interfaces is enabled using an EUI-64 interface ID in the low order 64 bits
of the address. If this option is used, the value of prefix_length must be 64
bits.
show hosts command on page 527 to display the
[eui64] | autoconfig | dhcp}
IP Addressing Commands
521