Classofservice Dot1P-Mapping - Dell Networking 7048 Reference Manual

console(config)#

classofservice dot1p-mapping

Use the classofservice dot1p-mapping command in Global Configuration
mode to map an 802.1p priority to an internal traffic class. In Interface
Configuration mode, the mapping is applied only to packets received on that
interface. Use the no form of the command to remove mapping between an
802.1p priority and an internal traffic class.
Syntax
classofservice dot1p-mapping
no classofservice dot1p-mapping
802.1ppriority — Specifies the user priority mapped to the specified traffic
•
class for this switch. (Range: 0–7)
trafficclass — Specifies the traffic class for this switch. (Range: 0–6)
•
Default Configuration
The default dot1p mapping is as follows:
User Priority
0
1
2
3
4
5
6
7
Command Mode
Global Configuration or Interface Configuration (Ethernet, Port-channel)
mode
664
QoS Commands
802.1ppriority trafficclass
Traffic Class
1
0
0
1
2
2
3
3