Static Reject Routes; Default Routes; Commands In This Chapter - Dell Networking 7048 Reference Manual

from different sources have the same preference, PowerConnect routing
prefers a static route over a dynamic route.

Static Reject Routes

To administratively control the traffic destined to a particular network so that
it is not forwarded through the router, PowerConnect enables configuring a
static reject route for that network on the router. Such traffic is discarded and
the ICMP destination unreachable message is sent back to the source. Static
reject routes are typically used to prevent routing loops.

Default Routes

PowerConnect routing provides a preference option for the configuration of
default routes. A configured default route is treated exactly like a static route.
Therefore, default routes and static routes have the same default preference.

Commands in this Chapter

This chapter explains the following commands:
encapsulation
ip address
ip mtu
ip netdirbcast
ip route
ip route default
ip route distance
ip routing
show ip brief
–
1008
IP Routing Commands
show ip interface
show ip protocols
show ip route
show ip route configured
show ip route connected
show ip route preferences
show ip route summary
show ip traffic
show ip vlan
show routing heap summary