VLAN Database — Contains commands to create a VLAN as a whole.
•
The Global Configuration mode command vlan database is used to enter
the VLAN Database mode.
Router OSPF Configuration — Global configuration mode command
•
router ospf is used to enter into the Router OSPF Configuration mode.
•
Router RIP Configuration — Global configuration mode command
router rip is used to enter into the Router RIP Configuration mode.
•
Router OSPFv3 Configuration — Global configuration mode command
ipv6 router ospf is used to enter into the Router OSPFv3 Configuration
mode.
•
IPv6 DHCP Pool Mode — Global configuration mode command ipv6
dhcp pool is used to enter into the IPv6 DHCP Pool mode.
Management Access List — Contains commands to define management
•
access administration lists. The Global Configuration mode command
management access-list is used to enter the Management Access List
configuration mode.
Policy-map — Use the policy-map command to access the QoS policy
•
map configuration mode to configure the QoS policy map.
•
Policy Class — Use the class command to access the QoS Policy-class
mode to attach or remove a diffserv class from a policy and to configure
the QoS policy class.
•
Class-Map — This mode consists of class creation/deletion and matching
commands. The class matching commands specify layer 2, layer 3 and
general match criteria. Use the class-map class-map-name commands to
access the QoS Class Map Configuration mode to configure QoS class
maps.
•
Stack — Use the stack command to access the Stack Configuration Mode.
•
Ethernet — Contains commands to manage Ethernet port configuration.
The Global Configuration mode command interface enters the Interface
Configuration mode to configure an Ethernet interface.
•
Port Channel — Contains commands to configure port-channels, i.e.,
assigning ports to a port-channel. Most of these commands are the same as
the commands in the Ethernet interface mode and are used to manage the
Using the CLI
183